Harbor Freight Tools 66163 Specifications, Unpacking, OPERATING Instructions, See Figure A

Specifications

Power Source	12 VDC
Plug Type	12 VDC Cigaretter Lighter Plug
Fuse Equipped	No. Must be connected to a fused 12 volt
	circuit.
	Wet & Dry Hand-Held Vacuum.
Features	High Power Motor for Efficient Cleaning.
	Detachable Container with Filter for
	Convenient Cleaning.
	Liquid Pick-Up Nozzle (Qty. 1)
Accessories	Small Crevise Nozzle (Qty. 1)
	Large Crevise Nozzle (Qty. 1)

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

OPERATING Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

To prevent serious injury

from accidental operation:

Turn the Power Switch (5) of the Auto Vacuum to its “OFF” position and unplug the tool from the vehicle’s cigarette lighter outlet before assembling or making any adjustments to the tool.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

1.To pick up solids, attach either the Long Nozzle (6) or the short Nozzle

(10)to the Collector (2) as follows: a) To attach the sort Nozzle (1), push the short end of the Nozzle into the opening at the front end of the Col- lector, making sure that the deflec- tor angle is in the same orientation as the tip of the Collector. Push the Nozzle in until snug. b) To attach the long Nozzle (6), slide it over the end of the short nozzle, again keeping in mind the orientation of the Nozzle opening with the angle of the Collec- tor opening.

2.To pick up liquids, insert the Liquid Pick-Up Nozzle (7) into the opening at the end of the Collector (2). IM- PORTANT: Make sure that the liquid vacuumed does not rise above the “MAX” mark on the Collector.

(See Figure A.)

3.To power the Auto Vacuum, insert the tool’s 12 Volt Power Plug (11) into a vehicle’s 12 volt cigarette lighter/ac- cessories outlet.

IMPORTANT: In certain vehicles, you may have to switch the ignition to the accessory mode before the Vacu- um will operate. (See Figure A.)

4.Press and hold the Power Switch

(5)to run the Auto Vacuum. While running, the Power-On Light (4) will illuminate. (See Figure A.)

SKU 66163 For technical questions, please call 1-800-444-3353. Page 5