Specifications
Charging Time | ||
Speed | 9000 OPM | |
(Oscillations Per Minute) | ||
| ||
Charger Input | 3VDC | |
Internal Battery |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this document as soon as possible.
Important SAFETY
Information
1.Do not expose to moisture while charging.
2.Do not reach for a plugged in Shaver that has fallen into water. Unplug immediately and drain water.
3.Do not charge near heater or in direct sun- light.
4.Do not use if Charger (5) or Charger cord has been damaged.
5.Do not attempt to remove Foil covering with screwdriver or other tools.
6.Do not use without Foil (2) and Foil Holder
(3) in place.
7.This product is not a toy. Do not allow chil- dren to play with this item.
8.Use as intended only.
9.Inspect before every use; do not use if parts are loose or damaged.
10.Turn off Shaver before charging.
11.Do not charge immediately after prolonged use. Allow it to cool before charging.
12.Rinse off Shaver after each use and keep stored in dry, cool environment out of chil- dren’s reach.
13.Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
CHARGING INSTRUCTIONS
1.Attach the power cord of the Charger (5) into the bottom of the Shaver (1). Plug the Char- ger into an electrical outlet that is away from a sink or other source of water. Note: Make sure Shaver Switch (8) is turned to OFF.
2.Once plugged in, the LED Charger light on the front of Shaver housing will activate.
3.Charge for 5 to 7 hours. Do not charge for longer than required charge time.
OPERATION INSTRUCTIONS
1.Once fully charged, remove Charger cord from housing, remove Cover (4) and turn Switch to ON.
2.Gently guide Shaver along face and chin to remove beard. Use short, back and forth strokes. Note: Do not apply too much pres- sure while shaving.
3.If you have not used an electric shaver before, your skin may become irritated after use. This is a natural reaction that may last for a few days until your skin adjusts to Shaver.
4.When finished shaving, turn Switch to OFF.
5.Slide the Cover onto Shaver head until ready to use again. For travelling purposes, slide the Shaver into the Carrying Sleeve (7).
CLEANING THE SHAVER
1.After each use, beard and hair cuttings may collect in Foil. Clean Foil by rinsing Shaver head under cool running water.
2.WARNING! Only clean when Shaver is dis- connected from Charger and switch is turned to OFF.
3.Hair trimmings may get under Foil and/or it may be necessary to replace Foil. First, press down on the tabs on either side of the Foil Holder (3).
4.Slide Foil Holder off of the top of Shaver housing, exposing the Shaver cutting heads.
SKU 66342 | For technical questions, please call | Page 2 |
