8.Do not assemble or use when tired or when under the influence of drugs or medication.
9.This product is not a toy. Do not allow children to play with or near this item.
10.Use for intended purpose(s) only.
11.Inspect before use; do not use if parts are loose or damaged.
12.Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Foodborne Illness Safety
1.Before every use, thoroughly clean the appliance (see “Cleaning” section for instructions) and wash your hands.
2.Follow Food and Drug Administration (FDA) food safety recommendations for cooking and food handling (www.fda.gov). Also, refer to the following safety information, taken from FDA’s website:
a.Keep hot food hot (above 140° F) and cold food cold (below 40° F). Do not let perishable food sit out longer than 2 hours (1 hour in temperatures above 90° F).
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
Assembly
1.Position the Cutting Frame (10 or 12) against the End Support (2).
2.Insert the longer threaded end of each of the three Support Rods (7) into the openings of the End Support (2) and Cutting Frame. Secure in place using three Wing Nuts (15).
3.Insert the Cutting Frame Bolt (16) into the opening at the top of the End Support (2) and Cutting Frame (10 or 12). Secure using one of the Wing Nuts (19).
4.Place the Food Tray (6) in position.
5.Place Lever Support (3) onto the ends of the
Support Rods (7) and fix in place using Wing
Nuts (15).
6.Place appropriate sized Push Block (11 or
13) on the Block Plate A (4) and fix in place by turning the Toggles.
7.Attach the Lever Assembly (1 and 8) to the Lever Support (3) using the Axle Bolt and Nut (17). Tighten the Nut still allowing the Lever to move freely.
8.Attach the Push Rods (9) to the Lever (1) using the Push Rod Bolt and Nut (18). Tighten the Nut still allowing the Lever to move freely.
Mounting the Tool
1.The tool is to be mounted to a wall or table.
2.The mounting surface must be flat or level and sturdy enough to support the weight of the tool, products placed on the tool and forces exerted when using the tool.
3.Remove the Lever Support (3).
4.Hold the tool in position and mark the four mounting hole positions. Set the tool aside.
5.Check to be sure that you will not drill into any concealed wires, pipes, hoses or ducts at the points marked. Drill holes at each of the four marked points.
6.Reposition the tool and attach it using suitable fasteners (not included).
Changing Push Block
and Cutting Frame
1.This item is supplied with two sets of Cutting Frames and Push Blocks for making different sized french fries.
2.To change size of french fry produced, change Push Blocks and Cutting Frames.
3.To remove Push Block (11 or 13), rotate the two swivel latches outward. The Block can be lifted out.
REV 09c; 09j
SKU 66473 | For technical questions, please call | Page 2 |
