Push Block Latches
4.To remove the Cutting Frame (10 or 12), remove the four wing nuts holding it in place. WARNING: Handle the Cutting Frame by the outer edge only. The blades are sharp and can cause injury if handled. The blades are not removable from the Cutting Frame.
5.To replace the Push Block, place it against Block Plate A (4) with hooks protruding through holes in Block Plate A. Then fix it in place with the two swivel latches.
6.To replace the Cutting Frame, position it on the end of the End Support (2) and attach it with the Wing Nuts.
Wing Nut (19)
Wing Nuts(15)
NOTE: Always use the Push Blocks and Cutting Frames in matched pairs. Using mismatched
Block and Cutting Frame will damage the tool.
Operation
1.Pull the Lever (1) back, which will pull the Push Block back from the Cutting Frame.
2.Place a bowl beneath the End Support (2) to catch the cut french fries as they are produced.
3.Place the potato or vegetable to be cut in the Food Tray (6). Align the vegetable roughly with the center of the Cutting Frame.
4.Press the Lever (1) forward. The Push Block will press the vegetable through the Cutting Frame. Stop pressing the Lever forward once the vegetable has been cut.
Cleaning
1.Remove both the Cutting Frame (10 or 12) and Push Block (11 or 13).
2.Lift Food Tray (6) out of tool.
3.Wash Cutting Frame, Push Block and Food Tray in dishwasher, or by hand using hot water and detergent.
4.Wipe off the rest of the tool using a clean damp cloth with light detergent. Wipe it dry after cleaning.
SKU 66473 | For technical questions, please call | Page 3 |
