If unreadable or missing, contact Harbor Freight Tools for a replacement.
Assembly Instructions
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
1.Open Rolling Walker. Push down on Support Hinges (41) until they lock securely in place. The Support Hinges are located directly be- low the Seat (16). See Figure 1, below.
16
41
Figure 1
2.The Brake Cable (7) should already be fastened to the Push Handles (2). Place the Push Handles into the Front Frame (17) and set to the required height using the Screw Caps (13) and Screws (10). Fasten securely. WARNING! Make sure that both Push Handles are set at the same height.
3.Insert the removable Backrest Bar (52) into the slots on the Front Frame and fasten into place by inserting the Retainer Pins (14).
See Figure 2, below.
52
14
Figure 2
4.Use the Fasteners (26) to clasp the Basket (25) or PVC Bag (51) to the Cross Bolt (27) and the Back Frame (18).
Operation
1.To properly sit in the chair, first make sure the Walker is on a level surface.
2.Then check the brakes and grab both Handles (4).
3.Carefully back into the Walker. Do NOT fall back into the Walker.
4.To slow down or temporarily stop the Walker during use, squeeze the Brake Handles (6) firmly. See Figure 3, below.
6 
Figure 3
5.To lock the Wheels (38) in position, push down on Brake Handles until a “click” sound is heard.
6.To unlock the Wheels, pull upon the Brake Handles.
7.Regularly test the tension on the Brake Handles to ensure that Brakes work properly. It may be necessary to adjust the tension of the brake cable. This type of adjustment is similar to the kind performed on a bicycle.
8.To tighten the tension on the brake cable, use a wrench (not included) to turn the 10mm Nut under the Handle clockwise. See Figure 4, below.
Brake Cable
10mm Nut
Figure 4
SKU 66838 | For technical questions, please call | Page 2 |
