Rear Grill. WARNING! Do not acti- vate Fan until properly latched.
8.Use Screws (24) to fasten Front and Rear Shaft Housing (23, 25) to Upper Shaft. See Figure B.
Operation
Read entire RULES FOR SAFE OPERATION section at beginning of manual including all text under subheadings therein before set up or use.
1.To make the fan oscillate, push the Knob (11) down. To make the fan stop oscillating, pull the Knob up.
2.To adjust the angle of air flow, tilt the
Housing (12) and move to desired angle.
3.To adjust height of fan, loosen the Height Adjustment Knob (28) and raise or lower fan. Retighten Knob once desired height is reached.
4.To activate, plug the Power Cord (36) into the nearest wall outlet.
5.To adjust the speed, push one of the desired Switches (21). The available speeds are Low, Medium and High.
To turn off fan, press the Off Switch.
INSPECTION AND MAINTENANCE
To prevent serious injury
from accidental operation or electric shock: Before appliance inspection or maintenance, make sure Off key is pressed and Power Cord is unplugged.
To prevent serious injury from Appliance failure: Do not use damaged appliances. If abnormal noise or vibration occurs, have the problem corrected before further use.
1.BEFORE EACH USE, inspect con- dition of the Fan. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, and any other condition that may affect its safe operation.
2.Clean regularly to prevent dust from accumulating on Propeller (4). Un- fasten latches along Front and Rear Grills, remove Front Gill, and use damp cloth to wipe Blade. Dry and replace Front Grill before use.
3.To maximize air circulation, dismantle Grills and Propeller and wash and dry each part when dirty.
4.WARNING! Do not allow any water to get into the Motor (8).
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts
thereto, or arising out of his or her installation of replacement parts thereto.
SKU 66950 | For technical questions, please call | Page 5 |
