5.WARNING! Turn the Brake Knob clockwise until it stops before lifting or lowering a load.
6.Move the Selector Lever to the up position (see Figure H) and ratchet the
Lever Handle to lift the load.
9.To lower the load, turn the Selector Lever to the down position (see Figure I) and ratchet until the load is resting fully on the work area.
WARNING! DO NOT LOWER BY TURNING BRAKE KNOB OR LOAD WILL FALL.
Turn Brake Knob clockwise to engage brake
D
U N
|
| 11/2 TON | |
|
| LEVER CHAIN HOIST | |
U | D | Figure I: 66106/96482 Selector Lever | |
N | |||
| |||
11/2 | TON | “D” / Down Position | |
LEVER CHAIN HOIST |
|
Figure H: 66106/96482 Selector Lever
and Brake Knob “U” / Up Position 10. Disconnect Hoist, clean, then store the tool indoors out of children’s reach.
Note: If there is slack in the load chain, you may |
|
|
| ||
need to pull on the load chain slightly to get the |
|
|
| ||
|
| ||||
ratchet to engage until the slack is taken up. |
| ||||
7. Lift load slightly and stop momentarily to make | (for all lever chain hoists) |
| |||
sure the load brake works before proceeding. | Procedures not specifically explained | ||||
WARNING! Keep bystanders and | |||||
in this manual must be performed | |||||
pets away when a load is raised. | |||||
only by a qualified technician. |
| ||||
Do not work under a raised load. |
| ||||
|
|
| |||
8. If the load is to be moved, lower it close to the |
|
|
| ||
|
|
| |||
ground prior to attempting to relocate the load. |
|
|
| ||
TO PREVENT SERIOUS INJURY |
| ||||
Do not touch the Selector Lever until | FROM TOOL FAILURE: |
| |||
the load is ready to be lowered. |
| ||||
Do not use damaged equipment. |
| ||||
|
|
| |||
|
| If abnormal noise occurs, have the |
| ||
|
| problem corrected before further use. |
| ||
|
| 1. BEFORE EACH USE, inspect the general | |||
|
| condition of the tool. Check for loose screws, | |||
|
| misalignment or binding of moving parts, | |||
|
| cracked or broken parts and any other |
| ||
|
| condition that may affect its safe operation. | |||
|
| 2. AFTER USE, clean surfaces of |
| ||
|
| the tool with clean cloth. |
| ||
|
| 3. WEEKLY, lubricate all chain links. Apply new | |||
|
| lubricant on top of the old layer of lubricant. | |||
|
| 4. PERIODICALLY, lubricate the moving |
| ||
|
| parts of the Hoist with white lithium |
| ||
|
| grease, but not the braking system. |
| ||
Lever Chain Hoist | For technical questions, please call | Page 7 |