Harbor Freight Tools 67437 Specifications, Unpacking, Assembly/operations Instructions

Specifications

Weight Capacity	250 lb.
Wheelchair Width	24”
Weight	40 lb.
Wheels	Solid Rubber Tires and
	360° Swivel Casters
Seat Width	20-1/4” x 16-5/8” Deep

4.Swivel Footplates (2) so they are horizontal.

5.To fold the Wheelchair, lock the Rear Wheels and fold Footplates up.

6.Pull up on the Seat and push Armrest closer together, folding the Wheelchair.

Unpacking

When unpacking, make sure item is intact and undamaged. If parts are missing or broken, call Harbor Freight Tools at 1-800-444-3353.

Assembly/operations

Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

For additional information regarding the parts listed in the following pages, refer to Assembly Diagram near the end of manual.

Unfolding/Folding

1.Before unfolding Wheelchair, make sure Rear Wheels (3) are in the locked position.

2.Hold the Armrests (10) and pull them away from one another, unfolding the Wheelchair.

3.As Wheelchair unfolds, press down on Seat (6).

Installing Foot Rests

1.Slide the Footplates (2) to the side (so that they are perpendicular to the Wheelchair. See Figure 1, below.

Figure 1

Foot Rest (1)

Tab

Control

Handle

Footplate (2)

2.Install the end of each Detachable Footrest (1) onto the tab extending from the Wheelchair Frame (9). See Figure 1, above.

3.Swivel the Footrest towards the inside of the Wheel Chair until it locks into place.

4.Please note: When properly installed, Footplate will be on the inside of the Wheel Chair when locked into place.

5.To remove, push the Control Handle out and lift the Foot Rest off the Wheelchair. See Figure 1, above.

SKU 67437 For technical questions, please call 1-800-444-3353. Page 6