Page 6 For technical questions, please call 1-800-444-3353. SKU 67698
overheating. Table A shows the correct
size to use depending on cord length
and nameplate ampere rating. If in
doubt, use the next heavier gauge. The
smaller the gauge number, the heavier
the cord.
Industrial applications must follow OSHA 16.
guidelines.
Maintain labels and nameplates on the 17.
compressor. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools for
a replacement.
This product is not a toy. Keep it out of 18.
reach of children.
Operate unit on level surface. Check 19.
oil level daily and ll to marked level if
needed.
People with pacemakers should 20.
consult their physician(s) before use.
Electromagnetic elds in close proximity
to heart pacemaker could cause
pacemaker interference or pacemaker
failure.
WARNING: The brass components of 21.
this product contain lead, a chemical
known to the State of California to cause
birth defects (or other reproductive
harm). (California Health & Safety code
§ 25249.5, et seq.).
By supplying this air compressor 22.
pump, Harbor Freight Tools makes
no representations and accepts no
responsibility for the motor, V-belt,
enclosure or mounting surface not
supplied by HFT which may be used
in the installation. You are strongly
advised to have this pump properly
installed by a qualied service technician
using appropriate components in good
condition.
The warnings, precautions, and 23.
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
sAVe THese insTruCTions.

grounding

To PreVenT
eleCTriC sHoCk
And deATH From inCorreCT
grounding wire
ConneCTion:
Check with a qualied electrician
if you are in doubt as to whether
the outlet is properly grounded.
do not modify the power cord
plug provided with the
compressor. never remove the
grounding prong from the plug.
do not use the compressor if the
power cord or plug is damaged.
if damaged, have it repaired by a
service facility before use. if the
plug will not t the outlet, have a
proper outlet installed by a
qualied electrician.