Harbor Freight Tools 67708 operating instructions Assembly/Mounting, Sample Air Line Setup

	Assembly/Mounting
	Bolt (64)
	Wheel (63)	Hex
Bolts (71)	Tank (70)
		Nuts
		(65)

Handle (72)	Wheel (63)
	Bolts (71)
	Bolt (64)

Figure 2

1.Attach the Wheels to the Tank, using the Bolts and Hex Nuts.

2.Slide the Handle into the two slots on the top of the Tank and secure in place with four Bolts.

Cylinder Head (7)

female Quick Coupler and fully open all regulators and valves.

b. Plug in the Power Cord.

c. Turn the Power Switch ON.

d. Let the unit run for 30 minutes. Air will expel freely through the Coupler.

e. Turn the Power Switch OFF.

f.Unplug the Power Cord and remove the male coupler.

5.Connect a regulator valve, an inline shut off valve and a 1/4” NPT air hose to the Quick Coupler (all sold separately). The air hose must be long enough to reach the work area with enough extra length to allow free movement while working.

Note: An in-line shutoff ball valve is an important safety device because it controls the air supply even if the air hose is ruptured. The shutoff valve should be a ball valve because it can be closed quickly.

Air Filter

(6)

Figure 3

3.Thread the Air Filter onto the side of the Cylinder Head.

4.Break in the new Air Compressor as follows:

a.Make sure the Power Switch is OFF and the unit is unplugged. Insert a male coupler (sold separately) into the

	Coupler	Coupler
	Plug	Plug
Tool
	Quick	Air Hose
	Coupler
		on Reel
Shut
Off	Oiler	Filter
Valve
		Air
		Compressor

Regulator with

Pressure Gauge

Sample Air Line Setup

6.Depending on the tool which you will be using with this compressor, you may need to incorporate additional components, such as an in-line oiler, a filter, or a dryer (all sold separately).

SKU 67708 For technical questions, please call 1-800-444-3353. Page 9