Assembly and mounting

Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.

NOTE: The following tools (none supplied) are required for mounting and installation: Stud Finder, 11/16” socket, ratchet handle, #2 Phillips screwdriver, 1/4” drill bit (for drilling into wood stud), 1/2” masonry drill bit (for drilling into brick or concrete wall), and minimum 6” level, 5mm hex wrench, and 10mm combination wrench.

Before Installing

1.Use the 5mm hex wrench to double-check that all four socket screws of the Wall Bracket (1) are tight. Tighten any connection, if needed.

2.Set Wall Bracket against the wall at the desired height. Place a level over the upper or lower cross bar and adjust Bracket until level. Use a marker to indicate locations of mounting holes.

Attaching to Wood Studs

1.First, verify woods studs are at least 16” apart.

Use a Stud Finder (not included) to find two adjacent studs 16” apart. Use a marker to indicate locations of the studs.

2.Drill four 1/4” holes at least 3-1/2” deep into the studs at the marked spots.

3.Use Lag Bolts (10) and Washers (9) to mount Wall Bracket to wall. See Figure 1, below.

Wall

Bracket

(1)

Lag Bolt (10) and Washer (9)

Figure 1

Attaching to Brick or Concrete Wall

1.NOTE: Verify at least 6” of space are between any two holes. Use 1/2” carbide tip masonry drill bit and drill four 3-3/8” deep holes.

2.Insert the Wall Anchors (11) into the holes, making sure they are flush with the wall surface.

3.WARNING! Wall Anchors must be set firmly against concrete or masonry. If mounting to

a masonry wall covered with drywall/plaster, counter bore a hole through drywall/plaster around mounting holes’ locations. This will allow Wall Anchors to be set directly against concrete or masonry. See Figures 2a and 2b, below.

Wall Bracket (1)

Lag

Concrete

 

Bolt (10)

 

Washer

 

Wall

(9)

 

Anchor (11)

 

Figure 2a

Wall

 

 

 

 

Bracket

 

Concrete

(1)

 

 

 

 

 

Lag Bolt (10)

Plaster/

Wall

 

Drywall

 

Anchor (11)

 

Figure 2b

4.Once Wall Anchors are securely set into concrete, use Lag Bolts and Washers to install

Wall Bracket to wall. See Figure 3, below.

Wall Anchor (12)

Wall

Bracket

(1)

Lag Bolt (11) and Washer (10)

Figure 3

Attaching to Metal Studs or Concrete

Block Wall

1.NOTE: If mounting to steel stud wall or cinder block wall, alternative mounting hardware is required.

Installing Support Arms to Flat Panel TV

1.WARNING! Verify TV is unplugged before threading any Screw into the TV’s back panel.

SKU 67781

For technical questions, please call 1-800-444-3353.

Page 2

Page 2
Image 2
Harbor Freight Tools 67781 specifications Assembly and mounting, For technical questions, please call