FUNCTIONAL DESCRIPTION
Functional Description
Specifications
Max. Air Pressure | 120 PSI |
| |
Air Inlet | 1/4” |
| |
Air Consumption | 1 CFM @ 90 PSI |
| |
Fastener | 11 Gauge, 3/4” to | ||
Capacity | Collated Roofing Nails |
| |
Magazine | 120 |
| |
Capacity |
| ||
|
| ||
|
|
|
|
| Components and Controls |
| |
| Mode Switch (41) | Air | |
|
|
| |
|
| Trigger (44) | Inlet |
|
|
| (100) |
Depth Knob
(52)
Safety (37) | Roofing |
Gauge (82) |
Safety Nosepiece - Also called the workpiece
contact, the Safety Nosepiece helps prevent the tool from firing unless it is pressed against an object.
Depth Knob - This controls the nail depth. Push the Knob to the left for shorter nails (or to fire nails less deep). Push the Knob to the right for longer nails (or for deeper depths).
Roofing Gauge - This can be adjusted to guide the shingle spacing. Loosen the Cap Screw, adjust Gauge as needed, then retighten the Cap Screw.
INITIALASSEMBLY
Initial Tool Setup/Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at 1‑800‑444‑3353 as soon as possible.
•This air tool may be shipped with a protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
1.Connect a regulator valve, an
SKU 68024 | For technical questions, please call | Page 7 |
