Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before
set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Unlock and release the Trigger and disconnect Battery Pack before adjusting tool or installing accessories.
Charging
1.Place the Battery Pack on a dry fireproof surface in a room where the temperature is from
Note: If recharging a newly spent Battery Pack, allow it to cool completely before charging.
Make sure the Battery Pack is undamaged; do not charge a cracked or leaking battery pack.
2.Disconnect the Cord from the Battery Charger. Attach the Adapter plug to a grounded, 120 V~, 60 Hz outlet.
3.Plug the Charger into the power supply and the green charging light will activate, showing that power is supplied to the Charger.
4.Slide the Battery Pack onto the Charger’s base. The red charging indicator light will activate
to show that charging is taking place.
Note: The Battery Pack’s capacity will increase somewhat during the first few charging cycles. A fully discharged battery will take about 3 to 5 hours to fully charge. CAUTION! Recharging the Battery Pack for more than 5 hours can damage the battery cells.
5.While charging, the Battery Pack and Charger, and Adapter may become warm to the touch. This is normal, and does not indicate a problem.
6.Unplug the Charger and disconnect it from the Battery Pack when finished.
7.Allow the Battery Pack to cool completely before using it.
8.Press the Battery Button to release Battery Pack from the Charger (or when removing it from the Saw).
9.Store the Charger and Battery Pack indoors, out of reach of children. WARNING! Do NOT use a different Charger or Battery to power this Saw.
General Operating Instructions
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Always make sure the Trigger Switch of the Cordless Reciprocating Saw is in its “OFF” position, the Battery Pack is disconnected prior to making any adjustments to the tool.
•DO NOT install the Battery Pack until AFTER you complete the following steps to set up the Saw for use.
•Refer to page 6 for the location of the parts of the Saw for the following steps.
Installing the Saw Blade
Note: Use only proper blades, otherwise the blade will not lock into the blade holder.
1.Choose the correct Saw Blade (Wood or Metal) for the material being cut.
2.Use the included Hex Wrench to loosen the Blade Clamp Screw located on the side of the Blade Holder.
3.Slide the Blade’s mounting edge into the Blade Plate and into the Blade Holder until it slides all the way in.
4.Use the Hex Screw to tighten the Blade Clamp Screw until blade is fastened securely into place.
| Blade Clamp |
Blade Plate | Screw |
Blade Cover
Blade Set
Screw
SKU 68240 | For technical questions, please call | Page 7 |
