Page 4 For technical questions, please call 1-800-444-3353. SKU 68421

Symbology

Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
v~ Volts Alternating Current
aAmperes

n0 xxxx/min. No Load Revolutions per Minute (RPM)

WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before set-up and/
or use.
WARNING marking concerning Risk of
Hearing Loss.
Wear hearing protection.
WARNING marking concerning Risk
of Fire.
Do not cover ventilation ducts.
Keep ammable objects away.
WARNING marking concerning Risk of
Electric Shock.
Properly connect power cord to
appropriate outlet.

Specications

Power Requirements 120 V~ / 60 Hz / 11.1 A
Maximum Flow 1150 GPH
Maximum Lift 154 FT.
Pressure 67 PSI
Motor 1-1/5 Horsepower Electric
Inlet and Outlet Diameter 1 IN. NPT
Cord Length 5 FT. 2 IN.
236418
JtS-441

unpacking

When unpacking, make sure that the item is intact
and undamaged. If any parts are missing or broken,
please call Harbor Freight Tools at 1-800-444-3353 as
soon as possible.

Set up

WaRnInG! This is NOT a submersible pump.
Do not immerse in water.

Pipe connection

The Pump uses 1" NPT piping (sold separately).
Purchase the necessary length of pipe, including any
needed ttings and bends. Mount the Pump as close to
the source of water as possible and within the range of
the rated Suction Lift. The connections must be airtight.
Wrap all threaded connections with PTFE tape (sold
separately).
1.
outlet
Priming
Plug
(23)
Inlet
cover (25)
Pump body (22)
Remove the Inlet and Outlet covers (25) from the
Pump.
2. Attach the water source to the Inlet, using
appropriate methods. The Inlet hose or pipe must
be collapse-proof to properly withstand the suction
force.
3. Install a foot valve and lter (sold separately) at the
bottom of the inlet.
4. Attach the outlet connection to the Outlet. A
Y-tting with dual valves (sold separately) is helpful
for priming the pump (see next section).