Safety
Setup
Operation
Maintenance
Using the Generator
Before Starting the Generator Engine
Before starting the engine:
a.Follow the Set Up Instructions to prepare the Generator.
b.Unplug all loads from the Generator.
c.Inspect the Generator and engine.
d.Fill the engine with the proper amount and type of both fuel and oil.
Basic Generator Use Procedure - See following pages for specific instructions
1.Check that the generator can handle the wattage needed to power your products.
2.Start the Engine, and allow the Engine and Generator to run and warm up for five minutes after starting with no electrical load.
3.Plug in products.
4.When finished using the Generator, disconnect all electrical loads.
Note: Do not allow generator to run out of fuel with loads attached.
5. Turn off the Engine.
Allow the Generator and its Engine to completely cool. Then store the unit in a clean, dry, safe location out of reach of children and other unauthorized people.
IMPORTANT: After starting the engine, allow it to run at no load for five minutes with no load after each start‑up so that the engine can stabilize.
6.
a.
b.The operational
•Do not apply a heavy load to the equipment.
c.The maintenance
•Change the engine oil.
Under normal operating conditions subsequent maintenance follows the schedule explained in the Service section.
Page 10 | For Pump technical questions, please call | Item 68526 / 68529 |
For Engine technical questions, please call |