Components and Controls (cont.)
The following are descriptions of the controls on the power panel. Your generator has sockets to power your products with circuit breakers to protect the voltage flow.
I
O
1.Engine Switch: Used to start and stop the Engine.
2.AC Receptacles: The Generator contains several AC receptacles to power tools and equipment.
a.
120 volt receptacle (NEMA
WARNING! Connect tools and equipment only to the Receptacle (120 volt or 240 volt) that is compatible with the electrical characteristics and rated capacities of the tools and equipment being used.
ON
OFF
3.Circuit Breakers: The circuit breaker protects the Generator from overloading. The rating of the breaker and the load it protects are marked near the breaker. Should any of the Circuit Breakers trip, the Generator will stop the electricity output. If this happens, unplug all loads from the Generator. Allow the Generator to cool down. Then, press the tripped Circuit Breaker, restart the Engine, and
4.DC Receptacle: 12 VDC Receptacle set provides a power source for 12 volt DC items.
5.Grounding Terminal: Prior to each use, set up the ground wire (not included) connection to the Grounding Terminal to properly ground the Generator. See Set up instructions
to properly ground the Generator.
Safety
Setup
Operation
Maintenance
Item 68526 / 68529 | For Pump technical questions, please call | Page 7 |
For Engine technical questions, please call |