y fet Sa
Setup
no rati Ope
ec
Maintenan
Troubleshooting
Problem |
| Possible Causes |
| Probable Solutions |
Inverter shuts off | 1. | Excessive load at output. | 1. | Reduce load to less than rated power. |
during use | 2. | Internal temperature | 2. | Let the Inverter cool down for at least 30 |
|
| is too high. |
| minutes. Make sure that the fan is not blocked |
|
|
|
| and that the Inverter has sufficient ventilation. |
No output voltage. | 1. Cords not connected properly | 1. | Check and secure connections | |
| 2. | Fuse on battery bank open | 2. | Check battery bank fuse and |
|
|
|
| replace as needed. |
| 3. | Internal fuse(s) open | 3. | Have technician check internal fuses |
|
|
|
| and replace as needed. Only a qualified |
|
|
|
| technician should open housing. |
| 4. | Low input voltage | 4. | Recharge or Replace Battery |
| 5. | Loose or corroded connection | 5. | Clean and tighten connection |
| 6. | High input voltage | 6. | Remove charging source and make |
|
|
|
| sure correct battery is being used |
|
|
|
| and connected correctly. |
Output voltage | Input voltage is too high or too low | Maintain input voltage at required level | ||
is incorrect |
|
|
|
|
Could not drive load | 1. Load power is too large | 1. | Lower load level | |
| 2. | The AWG of the wire is too low | 2. | Use |
| 3. | Start power of an appliance is | 3. | Reduce load, or change appliances |
|
| up to twice the rated power. |
|
|
Load is only inductive | Operate a lamp or heater at the same | |||
device operates at |
|
| time to provide a more balanced load. | |
incorrect speed |
|
|
|
|
Television picture is full | 1. | Television or radio interference | 1. | Move Inverter away from antenna and/ |
of static or speakers |
|
|
| or use a shielded antenna cable. |
make a buzz | 2. Incompatible device | 2. | Contact device supplier to make | |
|
|
|
| sure that device can operate on |
|
|
|
| Modified Sine Wave Power. |
Follow all safety precautions whenever diagnosing or servicing the inverter.
Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
Page 10 | For technical questions, please call | Item 69662 |
