Operation (continued)
HVLP Gravity Gun Adjustments
Refer to page 5 and the Assembly Drawing on page 11.
Note: We recommend you practice on scrap material to learn the fine tune adjustments.
1.To change the spray pattern, turn the Spray Pattern Adjust Knob (4a).
2.To regulate the amount of material entering the Spray Gun, adjust the Fluid Adjust Knob (11a).
3.To fine tune the air flow, adjust the Air Adjust Knob (17a).
Preparing and Operating Touch-up Gun
Refer to page 5 and the Assembly Drawing on pages 10 and 12.
Note: We recommend you practice on scrap material to adjust and become familiar with the Gun.
1.Detach the Plastic Cup (6). Fill the cup with material that has already been checked for viscosity (see page 6). Close the Plastic Cup (6) tightly to avoid leakage.
2.Mount the Plastic Cup (6) to the
3.Connect the air source hose to the Air Inlet (14b). Turn on your air compressor. Do not exceed the 50 PSI maximum.
4.Press the Trigger (5b) slowly and move the Spray Gun in parallel strokes to the object being painted. Keep the distance from the object being painted at 4” to 12”. This may slightly differ depending on the flow adjustment and the material being sprayed.
5.Release the Trigger (5b) after each forward movement; press the Trigger (5b) again on the return movement.
6.When using a vertical pattern, move the Spray Gun in a horizontal motion; with a hori- zontal pattern move the Spray Gun in a vertical motion. A round pattern requires a greater distance from the object being painted.
7.When finished, release the Trigger (5b) and disconnect from the air source. As the Plastic Cup (6) and Spray Gun may still hold air pressure, fire the Spray Gun toward scrap material until all of the pressure is expended.
Touch-up Sprayer Adjustments
Refer to page 5 and the Assembly Drawing on page 12.
Note: We recommend you practice on scrap material to learn the fine tune adjustments.
1.To change the spray pattern, turn the Air Nozzle (1b).
2.To regulate the amount of material entering the Spray Gun, adjust the Adjusting Screw (17b).
3.To fine tune the air flow, adjust the Air Regulator (3b).
Page 8
