Troubleshooting
PROBLEM |
| CAUSE |
| REMEDY |
|
|
|
|
|
| 1. | Paint too diluted | 1. | Add undiluted product |
Paint drips on the |
|
|
| (check viscosity) |
| 2. | Improper spray adjustment | 2. | Reduce paint flow by tightening |
object being painted |
|
|
| Paint Adjustment Screw |
| 3. | Too much air flow | 3. | Reduce air flow by turning Air |
|
|
|
| Adjustment Screw down |
| 4. | Holding Trigger too long | 4. | Release Trigger on back stroke |
| 5. | Spraying too close | 5. | Increase distance between |
|
|
|
| nozzle and object |
| 1. | Paint too diluted | 1. | Add undiluted product |
Paint Application |
|
|
| (check viscosity) |
uneven or irregular | 2. Improper spray adjustment | 2. | Increase paint flow by loosening | |
|
|
|
| Paint Adjustment Screw |
| 3. | Air flow too weak | 3. | Increase air flow by loosening |
|
|
|
| Air Adjustment Screw |
| 4. | Spray movement too fast | 4. | Move Spray Gun more slowly |
| 5. | Gun clogged | 5. | Clean components |
| 6. | Spray distance too far | 6. | Spray closer to object |
| 7. | Nozzle set too fine | 7. | Adjust Nozzle |
|
|
|
| |
Spray Gun not | 1. Paint not thinned enough | 1. | Add thinner (check viscosity) | |
operating | 2. | Spray Gun clogged | 2. | Clean components |
| 3. | Air Hose is broken | 3. | Replace Air Hose |
| 4. | Air Filter clogged | 4. | Clean or replace Air Filter |
| 5. | Paint Cup not fully closed | 5. | Close paint cup |
|
|
|
|
|
Maintenance
Disconnect the tool from the air source.
1.Remove the Spray Gun Plastic Cup (2 or 6).
2.Pour residual paint into the paint container and seal it.
3.Pour
4.Secure the Plastic Cup (2 or 6) to the appropriate Gun and shake the liquid in the cup.
5.Connect to the air source and turn on the air compressor.
6.Spray the liquid onto a piece of scrap material until the
spray material is free of paint.
7.Repeat if necessary.
8.After following the above procedure, use the brush and wire set to further clean the
Spray Gun. | Brush & Wire Set |
SKU 90985 | Page 9 |
