Troubleshooting
Note: Any repairs suggested below should be completed by an authorized service technician.
Trouble |
| Probable Cause |
| Correction |
|
|
|
|
|
Motor does not run | 1. | Blown fuse. | 1. | Replace fuse. |
when power switch | 2. | Switch is burned out. | 2. | Replace the Switch. |
is pressed on. | 3. | Connection wire is | 3. | Tighten or replace |
|
| loose or damaged. |
| the wire. |
|
|
|
|
|
Motor does not run | 1. | Power voltage is too low. | 1. | Test voltage. |
at full speed. | 2. | Motor is damaged. | 2. | Check and repair motor. |
|
|
|
|
|
Motor will not reach | 1. | Incorrect power wiring. | 1. | Have the unit rewired |
full power. | 2. | Overload. |
| professionally. |
| 2. | Reduce load by clean- | ||
|
|
|
| ing filters as necessary. |
|
|
|
|
|
Motor overheats. | 1. | Using wrong voltage. | 1. | Verify that the outlet is |
|
|
|
| 115 VAC. |
| 2. | Motor is damaged. | 2. | Check and repair the |
|
|
|
| motor. |
|
|
|
|
|
Insufficient suction | 1. | Inlet port blocked. | 1. | Clean inlet port. |
power. | 2. | 2. | Empty | |
|
| full. |
| Filter. |
| 3. | Outlet port blocked. | 3. | Clean the outlet port or |
|
|
|
| adjust the direction of |
|
|
|
| the outlet. |
|
|
|
|
|
Unit is shaking. | 1. | The unit isn’t properly | 1. | Mount the unit firmly. |
|
| anchored. |
|
|
| 2. | The unit isn’t level. | 2. | Level the unit. |
| 3. | Worn or damaged | 3. | Repair or replace |
|
| power cord. |
| power cord. |
|
|
|
|
|
SKU 91393 | PAGE 11 |
