3.If using only a 12 volt DC tool or equipment, turn the 110/120 volt AC Circuit Breaker (5) to its “OFF” position. (See Figure D.)
4.Start and run the Engine as previously discussed in this manual.
5.When finished using the Generator, turn the Engine Power Switch (2) to its “OFF” position. Turn the Fuel Valve (40) to its “OFF” position. Then, disconnect the electrical powered tools’ power cord from the Generator’s DC Terminals (7).
(See Figure H.)
6.After the Engine and Generator have completely cooled, store the Generator in a safe, clean, dry location (if not already installed in one).
7.NOTE: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit in case of an overload. Should an overload occur the Fuse will burn out, causing the Generator to automatically shut down. In this case, refer to Step #1 in this section. Then, reset the circuitry system by replacing the burnt Fuse with a new 10 AMP DC Fuse. Restart the Generator and continue powering the remaining tool or equipment. (See Figure H.)
POSITIVE (+) DC TERMINAL (7)
10 AMP
NEGATIVE
(9)
FIGURE H
SKU 91523 | PAGE 16 |
