Harbor Freight Tools 91924 manual Unpacking, Assembly and Operating Instructions

Assembling the Handle

UNPACKING

When unpacking, check to make sure that this product is in good condition, and all the following are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

Snow Thrower Main Component

Snow Thrower Handle

(2) Locking Knobs

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 13.

1.CAUTION: Always make sure the Power Cord is unplugged from its electrical outlet prior to assembling or making any adjustments to the tool.

2.Before using the Snow Thrower, you must assemble the Handle. Insert the upper part of the Handle into the lower part, as in the photo. There is an insertion mark on the handle. Do not insert beyond the mark. Be careful not to damage the electric cord inside the Handle. Tighten the Knobs.

3.To operate, the Snow Thrower must have 110-120 VAC power. Provide an extension cord (not supplied) of sufficient length, and meeting the re- quirements discussed in the previ- ous section. Be careful that the ex- tension cord does not lie in open water or on wet surfaces. Observe all safety precautions mentioned in this manual.

Upper

Handle

Knobs

4.If the Snow Thrower gets locked up

with ice or operates slowly or with difficulty, stop using immediately. Unplug the Snow Thrower and move

it to a slightly warm garage or other room where any water will be able to drain away from the Thrower without damaging the room. Ensure that all snow and water has completely melted and the Thrower has dried before use.

5.You can adjust the height of the thrown material among three settings, High, Me- dium, or Low.You do this by raising or lowering the height of the Rear Wheels, which changes the angle of the Snow Thrower.

SKU 91924 For technical questions, please call 1-800-444-3353. Page 10