Harbor Freight Tools 92122 Specifications, Unpacking, Initial Set Up Instructions

Models: 92122

1 5
Download 5 pages 39.96 Kb
Page 3
Image 3
Specifications

 

 

 

 

 

 

 

Specifications

 

 

 

 

 

 

Battery

 

Ni-cd, AA 1.2V, 600mAh (included)

 

 

 

 

 

 

 

Included

 

2 Stainless Steel Solar Lights

 

 

 

 

 

 

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

best results, the Lights should be placed in an area that receives at least eight hours of direct sunlight per day.

4.Place a Spike onto a Connector and then into the Shaft.

5.Push the unit firmly into the ground.

6.The Solar Light can be placed on the Shaft now.

7.Repeat these steps to assemble the other light.

Initial Set Up

Instructions

Read all warning sections at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

1.Unscrew the lens of the Head Fixture. Remove the four screws on the bottom of the Fixture. Open the battery compartment to verify that battery polarity is correct. Be careful not to pull on the wires connected to the casing, damaging the wires will render the unit dysfunctional. Close the unit and replace the screws.

2.Push the power switch to the ON position. Replace the lens.

3.Examine the area where the Solar Light is to be placed. Make sure there are no utility lines beneath the surface that might be damaged. For

Operating Instructions

1.Allow the Light to charge for a full day in direct sunlight, before first use.

Note: The on/off switch must be in the ON position when charging.

2.The Solar Light will turn on automatically when it gets dark, and provide illumination for up to eight hours.

3.Do not install the Solar Light near a nighttime light source. A bright light source will prevent the Light from turning on at night.

4.To store the unit, turn off the Light and disconnect its power supply after use. Clean, then store the Light indoors out of children’s reach.

SKU 92122

For technical questions, please call 1-800-444-3353.

Page 3

Page 3
Image 3
Harbor Freight Tools 92122 Specifications, Unpacking, Initial Set Up Instructions, Operating Instructions