Maintenance And Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
Cleaning, Maintenance, and Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.Periodically, clean external surfaces of the Light with clean, moist cloth. For best operation, clean the Solar Panel on the top of the Cap, so that the battery will charge efficiently.
3.Change the battery every year.
4.Dispose of the battery in a manner consistent with State, Local and Federal laws and regulations. Check with your local hazardous waste disposal facility for instructions.
TROUBLESHOOTING
The performance of solar light depends on the amount of direct sunlight available during daylight hours. If your solar light does not operate properly, refer to possible reasons listed below:
Dim Light:
1.The On/Off switch contacts may be poor. Turn the switch on and off several times to alleviate the problem.
2.The battery may be low or under- charged. Shadows will prevent the solar panel from fully absorbing sunlight, such as tree branches, any
shadow from trees, buildings, etc. Make sure the lights are located in an unobstructed location where they can receive 8 hours of sunlight a day. Allow the battery to recharge for 2 full, sunny days. Overcast days will limit performance.
3.Dirty solar panel (on top of the Cap). A dirty solar panel will not allow the unit to charge and will shorten the life of the battery. Use a soft, moist cloth to clean the solar panel. Do not use bleaches or detergents.
No Light:
1.The On/Off switch may be in the OFF position. Turn it to the ON position.
2.An external light source (i.e. streetlight, porch light, flood light) may prevent the light from automatically turning on at night. Reposition the Solar Light. Ensure the photocell of the solar light is not affected by any other light sources.
3.Battery may need recharging. Check the battery to ensure it is connecting with the terminals.
PLEASE READ THE FOLLOWING
CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he
or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising
out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
SKU 92122 | For technical questions, please call | Page 4 |
