COLLET
(26)
WRENCH (24)
COLLET NUT
(25)
GRINDING DRUM
(NOT INCLUDED) WRENCH (24)
FIGURE B
SPINDLE
(27)
5.Connect the air supply hose to the Quick Connector (34) on the Die Grinder. Turn on the air compressor, and set its regulator to the recommended 90 PSI for the Die Grinder. (See Figure A.)
6.In order to keep the air supply hose out of the way, hang it over your shoulder.
7.IMPORTANT! Grip the Die Grinder firmly with both hands.
8.Trip the Safety (8) with your finger. Then slowly apply hand pressure to the Trigger (4) until the desired speed is obtained. NOTE: The Die Grinder always turns the Grinding Drum clockwise. (See Figure C.)
SAFETY
(8)
TRIGGER
(4)
FIGURE C
9.With a firm grip on the Die Grinder, lightly apply the Grinding Drum to the workpiece, slowly and steadily moving the Grinding Drum to the right and left until you have achieved the desired appearance (finish) on the workpiece.
10.Once the work is completed, release hand pressure on the Trigger (4). The Safety (8) will automatically return to its locked position to prevent the Trigger from accidentally being activated. (See Figure C.)
11.Turn off the air compressor. Trip the Safety (8) with your finger, and slowly squeeze the Trigger (4) to release any remaining air pressure from the Die Grinder. Then, disconnect the air hose from the tool. (See Figure A.)
SKU 92144/92007 | For technical questions, please call | PAGE 7 |
