2.Prior to use, the Die Grinder requires the attachment of a Quick Connector (34) into its Air Inlet (1). To do so, wrap approximately 3” of pipe thread sealer tape (not included) around the male threads of a Quick Connector. Then, firmly tighten the Quick Connector into the Air Inlet. (See Figure A.)
RECOMMENDED COMPRESSED AIR SYSTEM
QUICK CONNECTOR (34)
| AIR INLET (1) |
AIR HOSE | QUICK CONNECTOR TO OILER |
(NOT INCLUDED) | (NOT INCLUDED) |
QUICK COUPLER REGULATOR (NOT INCLUDED) (NOT INCLUDED)
AIR HOSE
(NOT INCLUDED)COMPRESSOR (NOT INCLUDED)
|
|
|
| FIGURE A |
OILER | FILTER | |||
(NOT INCLUDED) | (NOT INCLUDED) |
| ||
To Operate The Die Grinder:
1.
WARNING! Always wear ANSI approved safety glasses, a full face shield, and hearing protection when operating the Die Grinder.
2.Use the two Wrenches (24) provided to loosen the Collet Nut (25).
(See Figure B, next page.)
3.Insert the Collet (26) into the Spindle (27). (See Figure B.)
4.Insert the 1/4” diameter shank of a Grinding Drum (not included) fully into the Collet (26). Then, firmly
SKU 92144/92007 | For technical questions, please call | PAGE 6 |
