Harbor Freight Tools 92403 manual Voltage Warning, Extension Cords

Models: 92403

1 8
Download 8 pages 3 Kb
Page 5
Image 5

Voltage Warning

Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the volt- age supplied is about the same as that specified on the nameplate of the tool. If one says 120V and the other says 110 VAC, then there will be no complications. Never try to plug a 110V tool into a 220V outlet, or the other way around. The plug and outlet have completely different shapes. This is because the power source with a voltage greater than that speci- fied on the tool can result in SERIOUS INJURY to the user - as well as damage the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage (110 VAC) less than the nameplate rating (220 VAC) is harmful to the motor.

Extension Cords

If your tool is double insulated and has a two-prong plug, you may use either a two or three-prong extension cord. If your tool has a grounded, three-prong plug, you must use a three prong extension cord with three-prong receptacles. Only use rounded jacket extension cords, preferably listed by the Underwriters Laboratory (UL). Make sure the cord is rated for outdoor use if you plan on using the tool outside; if you plan on indoor use you may also use an outdoor rated cord. Extension cords rated for outdoor use have the letters “WA” on the cord jacket.

The extension cord must have a minimum wire size depending on the amperage of the tool and the length of the extension cord. This size is signified by its AWG (American Wire Gauge) rating; the smaller the gauge, the greater the cable’s capacity. If you are using two or more cords, the total length of the combined cords must be used to determine the minimum AWG rating. Each of the cords used must meet this rating.

The chart below is used to determine the rating required according to the length of the cord (s). The amps of your tool are found either in this manual or on the nameplate of the tool.

Always inspect extension cords for any damage. If there are any loose, frayed or ex- posed wires, damaged insulation, or defective connections, replace the cord. Harbor Freight Tools can supply UL listed and outdoor rated cords in multiple AWG ratings if needed.

SKU 92403

For technical questions, please call 1-800-444-3353

Page

Page 5
Image 5
Harbor Freight Tools 92403 manual Voltage Warning, Extension Cords