Harbor Freight Tools 92623 operating instructions English

Models: 92623

1 29
Download 29 pages 46.33 Kb
Page 10
Image 10

3.Plug the Power Cord (41) into an electrical extension cord (not included). Then, plug the extension cord into a grounded, GFCI, 120 volt, electrical outlet.

NOTE: Always start and stop the Polisher while it is held firmly against the surface of the vehicle. Failure to do so may result in the Bonnet being thrown from the Polishing Pad (2).

4.To start, grip the Polisher firmly with both hands and press in on the Switch (36) trigger. Press the Lock-on Button to lock the Switch in the On position. Press in on the Switch to unlock again.

Position the unit on the area to be polished, select the desired speed by rotating the Speed Adjustment (37) knob, and allow the Polishing Pad (2) to rotate until it has reached that speed. Keep pressure off of the Polisher/Sander when operating. The Polishing Bonnet should LIGHTLY contact the polishing surface.

Caution: Only use the lower speeds (1 through 4) for polishing. Otherwise, damage may occur to the paint being polished. Harbor Freight Tools is not responsible for damage to the vehicle’s finish due to improper use of this polisher.

5.Begin applying wax to the vehicle.

Apply the wax to all flat surfaces with broad, sweeping strokes in a crisscross pattern. Apply the wax evenly over the surface of the vehicle, and add additional wax as needed.

6.After the wax has been applied to the vehicle’s surface, release the Switch (36) to its Off position. Then unplug the Power Cord (41) from the electrical extension cord.

7.Remove the Foam Pad (44) from the Polishing Pad (2) and with your hand and the Foam Pad (44), apply the wax to all hard to reach areas of the vehicle such as around lights, door handles, under bumpers, etc.

8.Allow sufficient time for the wax to dry on the vehicle.

9.Place a clean Polishing Bonnet securely onto the Polishing Pad (2). Note: Always tightly pull the string to secure the Polishing Bonnet. Secure the string and keep it out of the way by tying several knots.

10.Plug the Power Cord (41) of the Polisher into the electrical extension cord.

NOTE: Always start and stop the Polisher while it is held firmly against the surface of the vehicle. Failure to do so may result in the Bonnet being thrown from the Polishing Pad (2).

11.To start, grip the Polisher firmly with both hands and press in on the Switch (36) trigger. Press the Lock-on Button to lock the Switch in the On position. Press in on the Switch to unlock again.

12.Begin polishing the vehicle by lightly buffing off the wax residue in a circular pattern. Continue polishing until all the wax residue is removed.

13.When finished, release the Switch (36) to its Off position. Then unplug the Power Cord (41) from the electrical extension cord. Unplug the extension cord from the electrical outlet.

14.Remove the Polishing Bonnet from the Polishing Pad (2). With the Polishing Bonnet or Terry Cloth (46) in your hand, remove the wax from all hard to reach areas of the vehicle.

SKU 92623 For technical questions, please call 1-800-444-3353

English

Page 10

Page 10
Image 10
Harbor Freight Tools 92623 operating instructions English