INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Always let the Trigger (36) rest in its “OFF” position, remove the Battery (37) from the tool, and unplug the Charger (39) from its electrical outlet before performing any inspection, maintenance, or cleaning.
2.Before each use: Inspect the general condition of the Impact Wrench. Check for misalignment or binding of moving parts, cracked or broken parts, leaking Battery, damaged Charger wiring, chipped or broken sockets, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the prob- lem corrected before further use.
Do not use damaged equipment.
3.Daily: With a clean cloth, remove all dirt, grease, and oil from the Impact Wrench. Do not immerse the Impact Wrench in any liquids.
4.It may become necessary at sometime to replace or clean the two Carbon Brushes (29) when the Motor performance decreases, or stops working completely.
To replace the Carbon Brushes: Remove the two Brush Holder Caps (28). Then, remove the two Carbon Brushes (29), keeping track of the orientation and location of each. If either Carbon Brush is worn more than halfway, replace both Carbon Brushes. If the Carbon Brushes are just dirty, however, they may be cleaned by rubbing them with a pencil eraser. If cleaning and replacing used brushes, try to install them in the same holders and in the same direction they were removed. When installing the Carbon Brushes, make sure the carbon portion of the Carbon Brushes contact the Motor’s Rotor and that the springs face away from the Motor. Also, make sure the springs operate freely. After replacement or cleaning, replace the two Brush Holder Caps.
NOTE: New Carbon Brushes tend to arc or spark when first used until they wear and conform to the Motor’s Rotor.
5.
CAUTION! All maintenance, service, or repairs not listed in this manual are only to be attempted by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
REV 04/06
SKU 92798 | For technical questions, please call | Page 12 |
