Harbor Freight Tools 93011 manual Do not allow water or steam to enter the plug or socket

Models: 93011

1 12
Download 12 pages 46.56 Kb
Page 5
Image 5

4.Avoid unintentional starting. Make sure you are prepared to begin work before plugging in the Steamer.

5.Do not force the Steamer. This tool will do the work better and safer at the speed and capacity for which it was designed.

6.Never leave the Steamer unattended when it is plugged into an electrical outlet. Unplug it from its electrical outlet and allow it to cool before leaving.

7.Always unplug the Steamer from its electrical outlet and allow it to cool before performing inspection, maintenance, cleaning procedures, or changing accessories.

8.Do not allow water or steam to enter the plug or socket.

9.Wear heat resistant gloves. The water to make steam is heated to 212° Fahrenheit. Wear protective clothing and protect your hands.

10.Never remove the Filler Cap (5) or detach the Hose (4) while the appliance is operating or before it has cooled.

11.Do not pull on the Hose (4) or carry the unit by the Hose (4) or Power Cord (12).

12.Keep the work area clear of children, pets, and bystanders.

13.During operation, do not stand or step on the Boiler Unit (8) or Hose (4).

14.Never block the safety valve.

15.Only operate the unit when the Boiler Unit (8) is on a flat, level surface. Failure to do so will result in severe overheating, damaging the unit.

16.Never point the Hose (4) or any attachment at anyone.

17.Always keep all attachments away from the face and body. Beware of dripping hot water, and regularly empty collected condensation from the Steam Plate (6); especially prior to stripping ceilings and high areas.

18.After disconnecting power, wait at least two minutes before removing the Filler Cap (5) to refill the Boiler Unit (8).

19.Do not overfill the reservoir. Use only standard tap water. Never add detergents or chemicals.

20.Never use the Steamer when the Boiler Unit is in a suspended position. This will result in possible injury and damage to the unit.

21.Extreme care must be used when operating the Steamer in close proximity to standing water. Always be aware of the danger of electrocution from stored water in baths, sinks, etc.

22.Do not use the Steamer if the Power Cord (12) is damaged.

SKU 91098

PAGE 5

Page 5
Image 5
Harbor Freight Tools 93011 manual Do not allow water or steam to enter the plug or socket, Never block the safety valve