Unpacking
When unpacking, check to make sure that the product is intact and undamaged.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Assembly
You must install the Wheel Guard (3) before using your Angle Grinder
1.Align the tabs on the Wheel Guard (3) with the indents in the underside of the Gear Housing (19) and press the Guard into place as shown in the photo at right.
2. Rotate the Wheel Guard (3) into position as shown in the photo at left.
3. Tighten the Screw (5) in the Guard Clamp (4) to hold the Wheel Guard (3) firmly in place.
Tighten the Screw (5)
in the Guard Clamp (4)
tab
tab | press down, |
| then rotate |
Positioning the Wheel Guard (3)
You must install the Side Handle (24) before using your Angle Grinder.
1.You can install the Side Handle (24) in either the left or right side or the top of the Gear Housing (19).
2.Decide which position is best for you, providing the firmest grip while working. Pry out the Rubber Plug (23) which is covering the threaded hole you have selected. Place the Rubber Plug in a safe place where you can find it again if you need it.
3.Align the threaded end of the Side Handle (24) with the threaded hole in the Gear Housing (19) and screw it in clockwise until it is tight.
NOTE: Periodically check to be sure the handle remains tight. Never try to reposition the Side Handle while the tool is running.
NOTE: The wheel guard is shown in the correct final position in the photo at right.
Installing the Side Handle (24)
SKU 93179 | For technical questions, please call | Page 7 |
