Operation (continued)
5.After you finished sharpening all of the teeth set for your current angle, turn off the machine by pushing the Switch (5B) and unplugging the unit. See FIGURE 11
6.Loosen the Lock Wheel (18) and reset the angle so that the first tooth that hasn’t been sharpened is positioned against the Chain Stop (23) and locked in, as explained on page 6.
7.As you did with the first half of the chain, be sure to lower the Top Housing (4B) so that the Grinding Wheel (8) skims the chain tooth, and lock it in place. See page 6. Follow all of the steps on page 6 double checking everything before you plug in the machine and turn it on again.
FIGURE 11
Lock Wheel (18)
Remember to turn off the machine and unplug it if you need to make any adjustments.
8.After you repeat all of the steps under Sharpening on page 7, your chain is ready to be mounted on your saw.
Maintenance
1.Keep the Sharpener clean and free of dust, metal debris and dirt.
2.Check the Grinding Wheel before each use to make sure it isn’t damaged. Do not use a grinding wheel if it is chipped, cracked, or worn. You can check if the wheel has cracks not visible to the human eye by hanging it up by the central hole and tapping it with a non metal object (ie: screwdriver handle). If it is in good condition it will produce a metallic sound. A dull sound indicates a crack or break.
3.Replace the Grinding Wheel when it grinds down to a diameter of 3 inches.
SKU 93213 | For technical questions, please call | Page 8 |
