Operating Instructions:
1.Plug the Power Cord of the Pump (9) into the nearest 120 volt, grounded, electrical outlet, making sure to arrange a “drip loop” in the Cord. The Pump will now run continuously until it is unplugged from its electrical outlet. (See Figure G.)
POWER CORD
120 VOLT, GROUNDED, ELECTRICAL OUTLET
DRIP LOOP
(WATER) |
| FIGURE G |
|
|
2.Allow sufficient time for the Pump (9) to move water upward into the Jug (7). Once the Jug is filled to overflowing, the water will begin cascading downward into the three Small Bowls (6) and into the Large Bowl where it will again be pumped upward to repeat the process. (See Assy. Diagram.)
3.When finished using the Fountain, always unplug the Power Cord from the electrical outlet. Drain the Fountain of all water.Then store the unit in a clean, dry, safe location out of reach of children.
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Make sure the Power Cord of the Pump (9) is disconnected from its electrical outlet prior to performing any inspection, maintenance, or cleaning procedures.
2.Before each use, inspect the general condition of the Fountain. Check for cracked or broken parts, damaged electrical wiring, and any other condition that may affect safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.To clean the Pump Filter: A clogged or dirty Pump Filter will greatly reduce performance of the Fountain. To clean the Pump Filter, remove the Front Plate of the Pump to expose the Filter. Use a stream of clean water to clean the Filter and Impeller area inside the Pump. Then, replace the Front Plate.
4.Make sure the water supply used for the Fountain is not dirty, sandy, and does not contain any corrosive chemical products. Change the water when necessary and rinse out the ceramic Bowls (5, 6, 7) frequently.
SKU 93442 For technical questions, please call
