![](/images/new-backgrounds/1302450/3024503x1.webp)
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below:
Model______________ | Serial No._____________ | Purchase Date_______________ |
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly.
| Technical Specifications |
Material: | ABS Thermoplastic, low carbon steel clamps, ply vinyl flex hose |
Hose Dimensions: | (2) 4” diameter x 10’ |
Also included: | (1) Table Saw Hood 12” square, (1) Y Connector, (2) Blast Gates, |
| (2) Jointer |
Weight: | 13 Lbs. |
Safety Warnings and Precautions
WARNING: When using product, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
1.Keep work area clean. Cluttered areas invite injuries.
2.Observe work area conditions. Keep work area well lighted.
3.Store idle equipment. When not in use, the Dust Collector Accessory Kit must be stored in a safe and dry location to inhibit rust. Always lock up products and keep out of reach of children.
4 . Use the right product for the job. There are certain applications for which the Dust Collector Accessory Kit was designed. Do not modify the Accessory Kit and do not use this product for a purpose for which it was not intended.
5.Check for damaged parts. Before using any product, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for any broken or damaged parts and any other conditions that may affect its operation. Replace or repair damaged or worn parts immediately.
6.Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts will void the warranty.
7.Do not operate product if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the product.
8.Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face shield if you are producing metal filings and wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists.
9.Do not place the Hoses in walkways or in any trafficked location. Set up the Dust Collector Accessory Kit in a location where people or vehicles will not trip or run over the hoses.
SKU 93601 | For technical questions please call | Page 2 |