Assembly
1.Though the Dust Collector Accessory Kit is designed to offer a wide variety of applications, the following illustration depicts a typical assembly method to
2.Note: The Dust Collector Accessory Kit is designed to be attached to stationary power equipment tools and dust collectors having 4” diameter dust ports. Depending on the diameter of the dust port of your power equipment tools and dust collector, it may be necessary to attach size adapters (not included) to ensure a proper fit.
Figure 1-To Attach to One or Two Power Tools
Attaching to One Power Tool
Jointer Hood (6” square) (3) | 4” Diameter Blast Gate (2) | |
or | ||
4”Wire Hose Clamp (6) | ||
Table Saw Dust Hood (12’ square) (5) | ||
|
Dust |
|
|
Port | Dust |
|
Flexible Hose (1) | Port | Dust |
|
Collector
Attaching to Two Power Tools “Y” Fitting (4)
Power
Tool
Power
Tool
3.Check the length of Flexible Hose (1) needed to set up the Dust Collector Accessory Kit with your power tool. It may be necessary to cut the Flexible Hose (1). To cut the Flexible Hose (1), cut the plastic on the hose in a straight line between one coil of wire. Use a tin snip or wire cutter to cut the coil inside the hose.
4.Place a Wire Hose Clamp (6) over the Flexible Hose. Slide the Flexible Hose (1) onto the dust port. Slide the Wire Hose Clamp (6) so that it sits on both a section of Flexible Hose (1) and the dust port. Thread down the screw on the Wire Hose Clamp (6) until the Flexible Hose (1) is tight on the dust port.
5.Open and close the Blast Gate (2) to control the air flow from the Power Tool(s) to the dust collector. When this kit is attached to 2 power tools, always close the Blast Gate (2) of an unused dust collector hose.
SKU 93601 | For technical questions please call | Page 4 |
