Operation (continued)
Magazine (57) | Safety |
(48) | |
| Insert |
FIGURE 1 | Pins Here |
Magazine | Pin Length |
Latch (23) | Selector (64) |
Trigger (42) 
Air Inlet (22) 
Loading Pin Nails
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN RELOADING OR DOING ANY OTHER MAINTENANCE ON THIS TOOL. Other people in the work area must also wear ANSI approved impact safety goggles.
Warning! Make sure the Nailer is not attached to the air hose whenever loading the tool.
1.Press the Magazine Latch (23) up and slide the Magazine (57) back.
2.If you are using a different pin length than previously:
a.Remove all pins from inside the nailer.
b.Slide the Pin Length Selector (64) to the appropriate length setting. See Figure 1.
3.Holding the nailer
4.Close the Magazine (57) making sure the Magazine Latch (23) clicks shut. See Figure 1.
Operating the Nailer
1.Attach the Nailer to the air supply at the Air Inlet (22). Start your compressor and check the pressure making sure it is set at the recommended 90 PSI and not to go over the maximum 90 PSI.
2.To fire, place the nose of the Nailer on the workpiece. The Nailer should not fire if the nose is not depressed. Once depressed, gently and briefly squeeze the Trigger (42) once. Do not fire repeatedly. Pins could bounce off of one another, damaging the work piece or causing PERSONAL INJURY.
SKU 93656 | For technical questions, please call | Page 6 |
