OPERATING INSTRUCTIONS
To Properly Locate The Water Pump:
1.WARNING! Use this Water Pump outdoors only. Do not operate the Water Pump in a closed area or in a poorly ventilated area. When running, the Engine of this Water Pump produces carbon monoxide, a colorless, odorless, toxic fume that, when inhaled, can cause serious personal injury or death.
2.Keep your work area clean and well lit. Cluttered and dark areas invite acci- dents.
3.Do not operate the Water Pump in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. The Water Pump and its Engine can create sparks which may ignite the dust or fumes.
4.Make sure the Water Pump is located on a flat, level, sturdy surface capable of sup- porting the weight of the Water Pump and any additional tools and equipment.
5.Route the Intake Hose with its Intake Filter (21) fully immersed in the water supply source. Then, make sure to secure the Intake Hose in place to keep it from mov- ing once the Water Pump is turned on. NOTE: The maximum suction lift of the Water Pump is 26 feet. The Intake Hose should be kept as short as possible for more efficient operation.
6.Route the Discharge Hose to the desired discharge location. If necessary, connect additional Discharge Hoses to direct the discharge to the desired location. Then, secure the Discharge Hose in place to keep it from moving once the Water Pump is turned on.
Note: The maximum discharge length of the Water Pump is 86 feet. The Discharge Hose should be kept as short as possible for more efficient operation.
To Prime The Water Pump:
1.The Water Pump MUST be primed with clean water prior to each use of the Pump. To Prime the Water Pump, unscrew and remove the Priming Cap (11) located at the top of the Discharge Flange (10). (See Figure D, next page.)
2.Fill the Discharge Flange (10) to its top with clean water. Then, replace the Priming Cap (11). (See Figure D.)
SKU 93662 | For technical questions, please call | Page 10 |
