CAUTION: Make certain that the Stem (8) and Handlebar (1) are set at an appropriate height for the rider. Make certain that the Stem (8) is not raised beyond where it is secure in the Frame (13). Make certain it is stable and tightly in place before riding the Tricycle.
4.To raise or lower the Stem (8), use a hex wrench to loosen the Lock Bolt (3). Gently pull up on the Stem (8) or push it down until it is at the desired height. Make certain that it is centered with the frame and Front Wheel (26). Tighten the Lock Bolt (3) into
Attaching the Seat and Seat Bracket
1.Line up the Seat Bracket (11) with one of the two sets of holes in the
2.If desired, the Seat (10) can be rotated up and down or moved forward or backward by loosening the Nut located directly under the Seat (10).
Figure | Figure |
Nut under
Seat (10) 
Seat | Cotter | |
Bracket (11) | ||
Pin (14) | ||
| ||
| Axle (35) |
Attaching Rear Wheels
1.Slide one Rear Wheel (15) onto the Rear Axle (35). Slide on Washer (16) and insert Cotter Pin (14) through the outside hole in the Axle
Replacing Front Wheel
1.To fix or replace the Front Wheel (26), first remove Screws (24) from Front Wheel (26) rim- see Figure 4 and Assembly Diagram on page 6. Pull out Front Axle (25) and remove the Front Wheel (26). To put it back in position, line up Front Wheel (26) with holes in the Fork (29). Insert Front Axle (25), and thread in Screws (24).
Figure 4
Fork (29)
Front
Wheel (26)
Screw (24)
SKU 94142 | For technical questions please call | Page 4 |
