IMPORTANT: The Spray Gun must be cleaned immediately after use. Improper cleaning is a common reason for the Spray Gun not to work.
Fan Direction and Pattern Adjustment
Fan Direction
To change the direction of the fan from horizontal to vertical, loosen the Lock Ring and turn the Air Cap (1A) 90 degrees. After the adjustment, tighten the Lock Ring by hand. See FIGURE 3 below.
Lock Ring | Horizontal Fan |
FIGURE 3 | Air Cap | Vertical Fan |
|
|
Pattern Adjustment
Warning!! Never exceed the Maximum Inlet PSI of MAX PSI.
1.Adjust the air pressure during operation with the Trigger (23A) fully depressed and the Air Control Knob (25A) (see FIGURE 1 on page 6) fully open. If you need to reduce the air pressure for specific areas, use the Air Control Knob (25A) or adjust the air com- pressor.
2.To set the pattern size specific to the job, use the Pattern Control Knob (7A) (see FIGURE 1 on page 6). By turning it counterclockwise (all the way open), the pattern will flatten. Turn the Pattern Control Knob (7A) clockwise for a round pattern.
See FIGURE 4 below.
FIGURE 4
Flat/Open | Round/Closed |
SKU 94572 | For technical questions, please call | Page 10 | |
Troubleshooting section at end of manual. | |||
|
|
