the horizontal line as shown on the Oil Sight Gauge (19). If the level of oil is below the horizontal line, carefully unscrew and remove the Oil Fill Cap (11) and add new oil through the Oil Fill hole. Make sure not to overfill. Then screw in the Oil Fill Cap, being careful not to strip the threads. (See Figure D.)
OIL FILL
CAP (11)
KEEP OIL LEVEL
EVEN WITH RED DOT
OIL SIGHT
GAUGE
(19)
FIGURE D
2.Turn the Air Outlet Valve (48) to its CLOSED position. Then connect a high pressure air hose (not included) equipped with a quick connector to the Air Outlet Valve. If using a water filter and oiler in series with the Air Outlet Valve of the Air Compressor, connect the other end of the air hose to the water filter and oiler and connect the water filter and oiler to the air tool being used. If not using a water filter and oiler, squirt several drops of air tool oil into the air intake plug of the air tool. Then, connect the other end of the air hose directly from the Air Outlet Valve of the Air Compressor to the air tool.
(See Figure E, and Figure F, next page.)
TOP VIEW |
| CLOSED POSITION |
|
AIR
OPEN POSITION
OUTLET
VALVE
CONNECT
(48)
AIR HOSE HERE.
FIGURE E
SKU 94724 | For technical questions, please call | Page 11 |
