Harbor Freight Tools 94840 operating instructions LED readout

Figure 3			Figure 4
			LED readout
			Turn Control
		Charging	Stick
		Jack	On/Off
Battery Pack (4)			Switch
	Transmitter/Charger Unit (2)		Climb
			Control
			Stick

Operating the Radio Transmitter

1.The Transmitter uses 8 “AA” batteries (not included). Remove the Battery Compartment Cover (12)-see Figure 4. Insert the batteries into the Battery Compartment making certain to line up the batteries with the polarity indicated in the Battery Compartment. Press the Battery Compartment Cover (12) back into place.

2.The Radio Transmitter (2) transmits a signal to the airplane’s receiver.

3.The Radio Transmitter (2) has a LED display that will light up when the Transmitter is on. The LED readout will indicate the strength of the battery charge:

Green indicates the batteries are at full capacity Yellow indicates the batteries are at half capacity Red indicates the batteries need replacing.

4.The Radio Transmitter/Charger is turned ON and OFF with the On/Off Switch located midway between the Control Sticks-see Figure 4.

5.The Radio Transmitter/Charger has two Control Sticks.

The Control Stick located on the left moves vertically and controls the Climb. Push

the Climb Control Stick forward to turn on the twin motors and cause the Biplane to climb. Pull back on the Climb Control Stick to slow down the twin motors and cause the Biplane to lower altitude-see Figure 4.

The Control Stick located on the right moves horizontally and controls the direction of the Biplane. Pushing the Turn Control Stick right or left causes the Biplane to turn right or left.

6.Attach the Wind Ribbon to the Radio Transmitter Antenna.

Installing Propellers

1.Make certain Radio Transmitter is OFF and that the Battery Pack is unplugged.

2.The Biplane comes with spare Propellers. If necessary, remove the Nut holding each Propeller in place. Remove the Propeller. Install new Propeller.

SKU 98480 For technical questions please call 1-800-444-3353. Page 5