Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY INSTRUCTIONS

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 12.

CAUTION: Always make sure the Power Cord (26) of the Sander is unplugged from its electrical outlet prior to making any adjustments or assembling to the tool.

ATTACHING THE DUST BAG (12)

1.To attach the Dust Bag (12) to the Palm Sander, place the opening of the Dust Bag (12) on top of the opening of the Dust Port of the Palm Sander and press down. Snap it in place into the rectangular shaft at the back of the Sander.

2.The Dust Collection Chute will only work if the sandpaper has holes that line up with the 6 dust collection holes in the Backing Pad (22). (There are 4 other holes in the Backing Pad for the Screws).

ATTACHING SANDPAPER TO THE BACKING PAD (22)

1.Press the tab on the Clamps (17) inward on both sides of the unit and swing the clamps on both sides up, out, and down to loosen the clamp. See 1 & 2, right.

2.Cut the sandpaper to fit the 4” W x 41/2” L Sanding Pad (22), with a little extra to overlap and fit under the Clamps (17). Do not use torn or frayed sandpaper.

Sandpaper goes under here

3.After wrapping the overlapped edges

of sandpaper under the Clamps (17), snap the Clamps (17) back into place.

HOW TO USE THE SANDPAPER HOLE PUNCH (29)

Mount the Sandpaper Hole Punch (29) to a work bench using two counter sinking screws (not included). Press the sander (with the sandpaper attached to it), straight down onto the Sandpaper Hole Punch. Use the corner guides, on the Hole Punch, to assure the holes line up with the holes in the Backing Pad (22) of the Sander.

REV 02/07

SKU 95020

For technical questions, please call 1-800-444-3353.

Page

Page 9
Image 9
Harbor Freight Tools 95020 Unpacking, Assembly Instructions Attaching the Dust BAG, Attaching Sandpaper to the Backing PAD