Page 3SKU 95365 for technical questions, please call 1-800-444-3353.
unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken (see parts list/assembly diagram), please call Harbor Freight
Tools at the number shown on the cover of this manual as soon as possible.
asseMbly instructions
note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram on page 6 of this manual.
The Bicycle Workstand can be easily assembled by taking the following steps. The Work-
stand will stand on its own and will hold up to 150 Lbs, evenly distributed.
1. Set one Leg Assembly A (9) and Leg Assembly B (11) on each side of the Post (2)
so that the holes line up with the holes at the bottom of the Post (2). Through the
lowest hole, insert Screw (8) and thread on Nut (12)-see Figure 1. Through the next
hole up, insert the Screw (8) from the opposite direction and thread on Nut (12)-see
Assembly Diagram. Attach Leg Covers (10) to the end of each leg (not shown in
Figure 1).
Figure 1
Slide the Bottom Support Assembly Brace (7) down over the Post (2) until it is at
the adjustment holes. Set the Bottom Support Assembly Holder (4) and the Bottom
Support Assembly Brace (7) so that they line up on each side of the desired hole.
Thread the Handle Wheel (13) into the Bottom Support Assembly Brace (7). Slide
Washer (5) onto the threaded end of the Handle Wheel (13) and thread on Nut (6)
to secure it in place-see Figure 2.
2.
Post (2)
Screw (8)
Nut (12)
Leg Assy A
(9) Leg Assy B (11)
Screw (8)
Nut (12)
Leg Cover (10)