Open or Closed Bail
1.The Bail Arm (24) can be either set to an Open or Closed
2.When in the closed or down position, the Bail Arm (24) prevents line from being released and coming off of the Spool. When the Bail is opened, the line is ready to be released during a cast.
3.Crank the Handle to close the Bail Arm.
Loading the Spool
1.Open up the Bail Arm (24). Tie new line to the Spool Assembly (13). Close the Bail Arm (24) and begin winding the line on.
2.Make certain that the new line comes off the filler spool in the same direction it would come off the Spool Assembly (13). Keep tension on the line while winding. This can be done by feeding the line through a cloth
Setting Drag
Setting drag is a procedure used to reduce line breakage when the line is under stress.
1.Set the drag by running the fishing line over the Bail and through the line guides. Tie the fishing line to a secure point.
2.With the rod at an angle of about 45 degrees, apply pressure to the line.
3.Turn the Drag Knob Assembly (2) toward either the “Less”
The Line Clip
The Line Clip (28) is located on top of the Spool Assembly (13). Use the Line Clip (28) to hold the line firmly when the Bail is open. It will retain the end of the line when the Fishing Reel is not in use.
Casting
1.Grasp the rod with your rod hand. Capture the fishing line between your forefinger and the rod and open the bail.
2.With the bail open, swing the rod back behind your shoulder and then back out again in a smooth arc, releasing the line. When bait or lure hits the water, turn handle to reset Bail arm.
3.Effective casting takes practice. Become familiar with casting procedures by practicing in your yard or on location. When practicing in a yard, do not use sharp hooks.
4.Cast safely and efficiently; use eye protection to protect your eyes from sharp hooks during casting procedures.
REV 07c; 07h
SKU 95493 | For technical questions, please call | Page 4 |
