Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Assembly AND OPERATING Instructions
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.
WARNING! Make sure the Power Switch of the product is in its “OFF” position before making any adjustments to the product.
2.Decide where you want to place the Solar Light Set. Choose a location that receives full, direct sunlight a minimum of six hours a day. The location should not be near nighttime light sources such as porch lights or streetlights as this will cause the Solar Light Set to remain off.
3.The Solar Light Set will need to charge for at least twelve hours before using it for the first time. Allow to charge for two sunny days before the Solar Light Set is fully charged. During initial charging, set the switch to “Off”.
4.Located underneath the Battery Cover (9) is a Auto/Off Switch (7). The Switch can be set to either “Auto” or “Off”. Set the Auto/Off Switch to
5.Moving the Auto/Off Switch (7) to “Auto” will automatically turn on the Solar Light during the night. After the initial charge is set, check to see that the Light (2) is on by viewing the light at night or in a dark location. If the Light (2) is not lit, check the position of the “Auto” Switch.
6.Note: During the day, the Solar Panel converts sunlight into electricity, recharging the battery. The amount of light the Solar Panel receives depends on placement of the Solar Light, geographic location and weather. If the weather is cloudy and the panel did not receive a full charge, the Solar Garden Light may not achieve the full hours of operating time. It will catch up on its own after two to three days of full sun.
7.Set the Hummingbird, Dragonfly or Butterfly onto the Top Tube (3). Slide the Top Tube (3), into the Bottom Tube (4). Slide the Stake (5) onto the Bottom Tube (4).
8.Push the Stake (5) directly into the ground. Make certain that the path of the Stake
(5)is clear of lines, cables and conduits.
SKU 95588 | For technical questions, please call | Page |
