8.Depending on use, attach a Tip (1, 12, 13, 14, 15) to the Mixer (2) on the Torch Handle (5). (See Figure B.)
9.Open the Oxygen Valve Stem (9) on the Torch Handle (5). Adjust the Oxygen Regulator to the desired working pressure. Then, close the Oxygen Valve Stem on the Torch Handle. (See Figure B.)
10.Open the Acetylene Valve Stem (10) on the Torch Handle. Adjust the Acetylene Regulator to the desired working pressure. Then, close the Acetylene Valve Stem on the Torch Handle. (See Figure B.)
11.Hold the Torch Handle (5) in one hand and a flint lighter (not included) in the other hand. (See Figure B.)
12.
WARNING! Always point the Tip (1, 12, 13, 14, 15) away from other people when lighting.
13.Open the Acetylene Valve Stem (10) about 1/4 turn, and ignite the acetylene gas coming out of the Tip (1, 12, 13, 14, 15). (See Figure B.)
14.Slowly open the Acetylene Valve Stem (10) further until the smoke subsides and the flame jumps away from the end of the Tip (1, 12, 13, 14, 15) slightly.
(See Figure B.)
15.Slowly open the Oxygen Valve Stem (9) until a brilliant neutral flame is reached. (If the flame has a smooth inner cone, the flame is called neutral.)
(See Figure B.)
16.
WARNING! Always use appropriate welding goggles or welding helmet (with at least a #10 shade lens rating) when welding or cutting.
17.Once the welding or cutting job is competed, turn off the Oxygen Valve Stem (9). Then, turn off the Acetylene Valve Stem (10). (See Figure B.)
NOTE: Reversal of this procedure may cause damage to the Torch Handle (5). (See Figure B.)
18.Shut off both cylinder valves. (See Figure B.)
19.Drain the gas from the Oxygen Regulator by opening the Oxygen Valve Stem (9). Complete this Step on the acetylene side. (See Figure B.)
20.Release the pressure on the Acetylene and Oxygen Regulators by turning their Pressure Adjusting Screws counterclockwise. (See Figure B.)
SKU 95671 For technical questions, please call
