Features and Controls
Dust | Safety Switch (51) | Trigger (48) |
Bag (46) |
|
|
| Exhaust Direction |
|
| Lever (55) |
|
Wrench
Handle (47)
Rabbet Depth
Guide (17)
(Hidden from view)
Depth
Adjustment
Knob (24)
Fence (37)
1.Trigger and Safety Switch:
As a safety feature, the Safety Switch (51) must be pushed to one side to allow the Trigger (48) to operate.
2.Wrench Handle storage:
The Left Housing (3) has a slot to allow storage of the Wrench Handle (47) and Wrench (49).
3.Fence:
The Fence (37) can be adjusted to control the width of the cut from the edge of the workpiece. The Fence can only be installed on the Left Housing. It is held in place by the Locking Knob (18).
To adjust: Loosen the Wing Nut (38), slide the Fence (37) to the desired setting. Retighten the Wing Nut after adjustment.
Note: The Bolt (40) needs to be inserted through the Fence from the top down with the Washer (39) underneath the fence, otherwise the flats on the Bolt will not properly engage the Fence Bracket (41).
The markings on the Fence are intended as general guidelines only. For accurate measurements, verify the position of the Fence using a measuring tool after tighten- ing.
Page 11 | For technical questions, please call |
