Harbor Freight Tools 96141 Inspection, Maintenance, And Cleaning, Using the 120 V AC/DC Adapter

Models: 96141

1 6
Download 6 pages 30.31 Kb
Page 5
Image 5
Using the 120 V AC/DC Adapter

Using the 120 V AC/DC Adapter

1.Insert the plug end into the charge receptacle on the Spotlight.

2.Plug the 120V AC/DC Adapter into a 120V receptacle.

3.Allow the Spotlight to charge until the green LED comes on.

4.Remove the 120V AC/DC Adapter electrical plug from the outlet, and disconnect from the Spotlight.

Running the Spotlight

1.The Spotlight will run for approximately 28 hours on a fully charged battery while in LOW mode, and approximately 12 hours on a fully charged battery while in HIGH mode.

2.The LOW setting will run 6 LED’s while the HIGH setting will use all 16 LEDs.

3.Select HIGH or LOW modes to run the Spotlight by moving the switch.

4.Squeeze the Trigger to turn ON the Spotlight.

Trigger Lock

Trigger

Figure 2

5.Slide the Trigger Lock Switch down (see Figure 2) to lock the Trigger ON. To release the Trigger from locked position, lightly touch the Trigger.

6.Remove finger away from the Trigger to turn the Spotlight OFF.

INSPECTION, MAINTENANCE, AND CLEANING

1.Running the SpotlightWARNING! Make sure the Trigger is in its “OFF” position before performing any inspection, maintenance, or cleaning procedures.

2.BEFORE EACH USE, inspect the general condition of the Spotlight. Check for cracked or broken parts and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

SKU 96141

For technical questions, please call 1-800-444-3353.

Page

Page 5
Image 5
Harbor Freight Tools 96141 Inspection, Maintenance, And Cleaning, Using the 120 V AC/DC Adapter, Running the Spotlight