15.Guard against electric shock. Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerator enclosures.
16.Replacement parts and accessories. This product is to be repaired and serviced only by a qualified technician. When this product is serviced, only identical replacement parts should be used. Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories are available from Harbor Freight Tools.
17.Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool.
18.Use proper size and type extension cord for an air compressor. If an extension cord is required, it must be of the proper size and type to supply the correct current to the compressor without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the compressor.
Check your air compressor’s manual for the appropriate size cord. It is also possible that the use of an extension cord may cause your circuit breaker to trip or your panel fuse to break. If this happens, either use the compressor without an extension cord or find a larger amperage circuit to use.
19.Maintenance. The maintenance outlined in the “Maintenance” section should be performed regularly. For your safety, this product should be serviced or repaired regularly only by a qualified technician.
20.Compressed air only. Use clean, dry, regulated, compressed air at between 70 and 120 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gases a power source for this tool.
21.Do not load brads with the trigger or safety depressed. Unintentional firing may occur. Do not load brads when the air hose is connected to the tool. Always assume the tool contains brads.
22.Disconnect air supply before loading the Nailer. Before reloading (or making any adjustments to) the Nailer, make sure the compressed air is disconnected.
23.Fire brads into an appropriate work surface only. Do not attempt to fire brads into surfaces too hard to penetrate. Do not drive brads on top of other brads, or at too steep an angle. Brads can ricochet, causing personal injury.
Never fire the Nailer into the air, or point it toward yourself or another person.
Always wear ANSI approved impact safety goggles during use, maintenance, and reloading.
24.Do not fire brads too close to the edge of a workpiece. They may split the
SKU 94481 | For technical questions, please call | PAGE 4 |
