FIGURE E
SPARK PLUG
COVER
(4D)
SPARK PLUG WIRE
(18)
SPARK PLUG
(2B)
0.020”
6.When storing the Saw, make sure to store the unit in a clean, dry, safe location out of reach of children and other unauthorized people. For long periods of stor- age, drain and clean the Fuel Tank (2C, 10C).
7.CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.
TROUBLESHOOTING
Problem |
| Possible Solution | |
| 1. | Check for amount of fuel. | |
| 2. | Make sure Choke Lever is in proper position. | |
| 3. | Make sure Spark Plug Wire is not loose. | |
| 4. | Check condition of Spark Plug. Wipe off any access fuel with | |
|
| a clean, dry cloth. Prior to reinstalling the spark plug, vent the | |
Engine will not start or runs |
| combustion chamber by pulling the start grip several times. | |
5. | Make sure Air Filter assembly is clean. | ||
poorly. | 6. | Make sure to press Decompression Valve before starting. Clean/ | |
| |||
|
| replace valve if it pops up without being pulled when unit is off. | |
| 7. | Have a qualified service technician check the ignition system. | |
| 8. | Have a qualified technician check/adjust the carburetor. The | |
|
| carburetor is not set to run satisfactorily at altitudes above 5,000 | |
|
| ft. | |
Engine smokes excessive- | 1. Check for proper mix of fuel. | ||
ly when running. | 2. Check Air Filter condition. | ||
| 1. | Check for proper mix and amount of fuel. | |
Saw Blade not rotating up | 2. Check condition of Spark Plug. | ||
to full speed. | 3. | Adjust tension on | |
| 4. | Check Air Filter. | |
Poor quality of cut. | 1. | Make sure Blade is undamaged. | |
2. | Make sure Saw Blade is properly installed. | ||
| |||
Kill Switch does not turn off | Immediately discontinue use of Cut Off Saw. Have a | ||
Engine. | qualified service technician check the Kill Switch. | ||
SKU 98089 | For technical questions, please call | PAGE 16 |
